🏁 The Team Associated RB10 Factory Team Retro Kit combines the iconic style of vintage competition buggies with a modern design derived from the B5 platform. This buggy 1/10 2WD electric kit features a rear-motor layout and stands out with its Retro Bronze anodized aluminum chassis, its exclusive gray body parts, and its Viper body with a vintage look. Designed to recapture the spirit of classic RC racing while taking advantage of modern, adjustable, and rugged components.
- Model: RB10 Factory Team Retro
- Type: Buggy Off-Road
- Scale: 1/10
- Version: Build-it-yourself kit
- Power: Electric
- Drivetrain: 2-wheel drive (2WD)
- Rear-engine layout
- Design based on the Team Associated B5 platform
- B5 tub chassis in Retro Bronze anodized aluminum
- Retro Bronze anodized aluminum front plate
- Aluminum engine plate with Bronze finish
- New front and rear cell castings
- Exclusive gray plastics to enhance the retro style
- Retro Viper body included
- 5.5-inch Retro rear wing with high downforce
- Dish rims with 12 mm hex
- Tires not included
- 13 mm large-volume shock absorbers
- Shock absorber bodies with Kashima coating
- Hydraulic shock absorbers with coil springs
- B5 Stealth rear-motor drivetrain
- CVA rear drive shafts
- Internal gear ratio: 2.6:1
- B5 ball differential
- Adjustable V2 slipper system
- Steel adjustment link
- Camber adjustment
- Front toe adjustment
- Fully adjustable suspension geometry
- Vertical ball joints for adjusting the roll center at the front and rear
- Fully metric fasteners
- Fully ball-bearing mounted
- Length: 400 mm
- Width: 248 mm
- Wheelbase: 266.7 mm
- Internal gear ratio: 2.6:1
- Weight: varies depending on the equipment installed
- 1 Team Associated RB10 Factory Team Retro Kit 1/10
- B5 Retro Bronze aluminum chassis
- Retro Bronze aluminum front plate
- Bronze aluminum motor plate
- B5 Stealth transmission
- B5 Ball Differential
- CVA rear drive shafts
- 13 mm large-volume shock absorbers with Kashima coating
- Adjustable V2 Slipper Clutch System
- Viper Retro Body
- 5.5" Retro rear wing
- 12 mm hex Dish rims
- Ball bearings
- Screws and parts needed to install the kit
To complete and operate the vehicle, you will need:
- Electric motor
- ESC electronic speed controller (ESC)
- Steering servo
- Radio transmitter
- Receiver
- Battery
- Compatible charger
- Tires suitable for the rims and the driving surface
- Paint and finishing supplies for the body, if needed
The Team Associated RB10 Factory Team Retro Kit is designed for 1/10 buggy enthusiasts who appreciate the aesthetics of classic competition models without wanting to sacrifice the tuning capabilities of a more modern platform. Its rear-motor layout, Factory Team components, and its Retro Bronze chassis make it both a project built for track use and a particularly appealing model for RC enthusiasts vintage.
